If you are a pet owner, you know how important it is to keep your furry friend hydrated, especially during hot weather. One of the best ways to ensure that your pet drinks enough water is by providing them with a water fountain. Petco’s water fountain is a great option for cats and dogs, but you might find it a bit challenging to assemble it. If you have just purchased a Petco water fountain and are wondering how to put it together, keep reading! In this article, we will guide you through the process step-by-step.
Before you start assembling the Petco water fountain, make sure that you have all the necessary parts. The fountain comes with a motor, a power cord, a filter, a foam filter, a water reservoir, and a bowl. Once you have everything, you can start assembling the fountain using the following steps:
Step 1: Wash all the parts
Before assembling the Petco water fountain, wash all the parts with soap and water. Make sure to rinse them well and wipe them dry. This step will ensure that your pet’s water is clean and free of any contaminants.
Step 2: Install the filter
The first step in assembling the Petco water fountain is to install the filter. The filter helps keep the water clean and fresh. To install the filter, remove the top cover of the motor and insert the filter into the slot provided. Make sure that the filter is placed in the correct position, with the side labeled ‘IN’ facing towards the motor.
Step 3: Insert the foam filter
Once the main filter is in place, insert the foam filter into the slot on top of it. The foam filter helps to remove any debris or hair that might find its way into the water.
Step 4: Install the motor
Next, place the motor unit into the bottom of the water reservoir. The motor should fit snugly into place, with the cord facing towards the rear of the fountain.
Step 5: Add water
Once the motor is in place, add water to the reservoir. Make sure that the water level is above the minimum line and below the maximum line. Do not overfill the reservoir, as this can cause the water to spill over the sides.
Step 6: Attach the bowl
After adding water, attach the bowl to the top of the fountain. Make sure that the bowl is securely in place and that the water flows freely from the top of the fountain into the bowl.
Step 7: Plug in the power cord
Finally, plug in the power cord and turn on the Petco water fountain. You can adjust the flow of water using the control knob on the motor unit.
In conclusion, assembling the Petco water fountain is a simple process that can be done in just a few easy steps. By following the above guidelines, you can ensure that your pet has clean and fresh water to drink, reducing the risk of dehydration and other health concerns. The fountain is easy to maintain, and you can clean it by removing all the parts and washing them with soap and water. We hope that this article has been helpful in guiding you through the assembly process and that your pet enjoys their new water fountain.
Table of Contents
- How To Assemble Catit Water Fountain?
- How To Assemble Wilton Water Fountain?
- Petco Water Fountain How To Replace Filter?
- How To Assemble Petsafe Water Fountain?
- Petco Water Fountain How To Replace Filter Dark Side Where?
- How To Hook Up Petco Water Fountain?
- How To Assemble Stair Water Fountain By Ashland?
- How To Assemble Ashland Buddah Water Fountain?
- How To Assemble Water Fountain?
- How To Assemble A Elephant Water Fountain?
Last update 2023-12-05